System information

3. Commands
4821-A2-GB21-00 July 2004 3-123
Show Security IP
show security ip [port_id]
Minimum Access Level: User
The show security ip command displays the settings for IP address security.
port_id – Specifies the port to be displayed. The possible forms of the identifier are described in
System Terminology in Chapter 2, Terminology and Conventions. If all is specified or the
parameter is omitted, information for all ports is displayed.
Example:
PDYN# show security ip 17
Port 17
State: Enabled
Maximum IP addresses: 5
IP Address NHR Type
135.90.28.10 135.90.28.1 static
135.90.28.11 135.90.28.1 dynamic
135.90.28.12 135.90.28.1 dynamic
PDYN#
Display results:
State – Whether IP security is in effect (disabled or enabled).
Maximum IP addresses – Maximum number of IP addresses allowed on the port.
Port – DSL port ID.
IP Address – IP address allowed on the port.
NHR – Next Hop Router for the port.
Type – The source of the address:
– dynamic – The address was learned.
– static – The address was added to the table of allowed addresses by the administrator.