System information

3. Commands
3-110 July 2004 4821-A2-GB21-00
Show Interface DSL Statistics Line Far End
Show interface dsl {port_id} statistics-line-far-end [bucket_number]
Minimum Access Level: User
The show interface dsl statistics-line command displays statistics for the specified ADSL port.
port_id – Specifies that the display should be limited to this specified port.
bucket_number – Optional parameter to specify the maximum interval (1..96) to display. If no
bucket number is specified then all intervals are displayed. If bucket_number is entered, then all
buckets up to the specified bucket are displayed. The current interval is always displayed.
Example:
PDYN# show interface dsl 1/2 statistics-line-far-end
FAR END ADSL STATISTICS
Interval LOFS LOSS LPRS ES SES UAS
current xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
1 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
2 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
3 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
. xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
. xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
. xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
95 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
96 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
Display results:
ES (errored seconds) – Seconds during which an error occurred.
SES (severely errored seconds) – Seconds during which there was a major error such as an
out of frame condition, or a bit error density greater than 10
–2
.
LOFS (loss of frame seconds) - Counts accrued after loss of frame detected
LOSS (loss of signal seconds) – Counts accrued after loss of signal detected
LPRS (loss of power) - Counts accrued after loss of power detected
US (unavailable seconds) - Counts of unavailable seconds.