System information

3. Commands
4821-A2-GB21-00 July 2004 3-109
Show Interface DSL Statistics ATM
Show interface dsl {port_id} statistics-atm [bucket_number]
Minimum Access Level: User
The show interface dsl statistics-atm command displays ATM statistics for the specified ADSL
port.
port_id – Specifies that the display should be limited to this specified port. If all is specified,
information is displayed for all ports.
bucket_number – Optional parameter to specify which statistic interval (1..96) to display. If no
bucket number is specified then all intervals are displayed.
Example:
PDYN# show interface dsl 1/2 statistics-atm
ATM STATISTICS
Interval Rx-Cells Tx Cells HEC OCD
current xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
1 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
2 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
3 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
. xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
. xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
. xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
96 xxxxxxxx xxxxxxxx xxxxxxxx xxxxxxxx
ATM PVC Performance
VCC 0/35
total cells sent xxxxxx
total cells received xxxxxx
VCC 0/40
total cells sent xxxxxx
total cells received xxxxxx
Display results:
ATM Statistics (Up and Down denote values for the upstream and downstream directions):
total cells rx – Total number of ATM cells received.
total cells tx – Total number of ATM cells sent.
total HEC – Number of cells from the CPE whose headers were corrected.
total OCD – Number of Out of Cell Delineation events on the link from the CPE.
ATM PVC Performance
total cells sent – Number of ATM PVC Cells sent by the port.
total cells received – Number of ATM PVC cells received on the port.