Installation manual

T1 Auxiliary Backplane
3-33000-A2-GA31-F0 March 2001
2. Determine the screw holes in which to mount the
T1 auxiliary backplane.
The backplane has pointer symbols next to the
center and bottom rows of screw holes.
If mounting
the backplane
on the . . .
Then use the . . .
Right side of the rear
of the carrier
Two screw holes with
the pointers facing to
the right ".
Left side of the rear of
the carrier
Use the holes with the
pointers facing left A .
PORT
1
PORT
1
PORT
1
PORT
1
PORT
1
PORT
1
PORT
1
PORT
1
CLOCK IN
DIAGNOSTIC
CHAN
PORT
2
PORT
2
PORT
2
PORT
2
PORT
2
PORT
2
PORT
2
PORT
2
DTE
DTE DTE DTE DTE DTE DTE
DTE
SLT 8 (16)
SLOT 6 (14)
SLOT 7 (15)
SLOT 5 (13)
SLOT 4 (12) SLOT 3 (11)
SLOT 2 (10)
SLOT 1 (9)
T1 NETWORK
INTERFACE
COMCODE
107170409
MODEL NO.
3100-F1-900
DIAGNOSTIC
CHAN
CAUTION:
DISCONNECT ALL TELEPHONE LINES AT THE NETWORK
INTERFACE BEFORE TOUCHING OR SERVICING
496-14814-01
SLOT 6 (14)
SLOT 7 (15)
SLOT 3 (11)
SLOT 2 (10)
T1 NETWORK
INTERFACE
Pointer
Symbol
For the top row, use the same screw holes for
mounting on either side
.
3. Align the backplane at the bottom and the
corresponding holes on the bottom row of the
backplane.
4. Insert and finger-tighten the two bottom row
screws.
If you are mounting the backplane on the left side,
insert the small 3/8″ screw into the open slot at the
lower left side of the backplane. Use 3/4″ screws
for the other bottom hole, and for both bottom
holes of a backplane mounted on the right side.
00-16860
Auxiliary
Backplane
Custom
Hexagonal
Standoff
Backplane Mounted on Left Side
00-16861
Backplane Mounted on Right Side