Installation manual

Installing the Carrier and Assembly Components
2-53000-A2-GA31-F0 March 2001
496-14763-01
Install
First
The carrier cabinet may or may not have threaded
screw holes.
If the cabinet . . .
Then . . .
Has threaded
screw holes
Use the short Phillips-head screws
included in the hardware package
and follow the procedure in
Installing a Carrier With Threaded
Screw Holes in the next section.
Does not have
threaded screw
holes
Use the self-retaining nuts and the
longer Phillips-head screws
included in the hardware package
and follow the procedure in
Installing a Carrier Without
Threaded Screw Holes on page
2-6.
NOTE
Installing the carrier may be a
two-person task. One person
holds the carrier in proper
alignment, and one person
installs the screws.
Installing a Carrier With
Threaded Screw Holes
" Procedure
1. Place the carrier against the front rails at the
bottom of the cabinet to determine where the two
lower machine screws should be installed. Then,
set the carrier aside.
Front Rail
Mounting
Bracket
Keyhole
496-12294-02
Front of 19-inch Carrier Cabinet
7th Hole
2. Use a screwdriver to install the two screws loosely
enough to allow the bracket keyholes to drop
under the screw heads during installation.
3. Place the carrier against the front rails of the
cabinet again, allowing the installed machine
screws to pass through the keyholes.
4. Lower the carrier into place, allowing the
keyholes to slide under the screw heads.
This positions the carrier correctly for installation
of the two remaining machine screws and helps
support its weight during installation of these
screws.
5. Install the two remaining machine screws at the
top corners of the carrier and tighten all four.
6. Install the next carrier in the same manner (from
the bottom up) using Steps 1 through 5.