User`s guide

S-REGISTERS (continued)

S58 Remote Access Password 00 00–99

5th and 6th digits

S59 Remote Access Password 00 00–99

7th and 8th digits

S62 V.25bis Coding 0 0=ASCII; 1=EBCDIC

S63 V.25bis Idle Character 0 0=Mark; 1=Flag

S64 V.25bis New Line Character 0 0=CR+LF; 1=CR; 2=LF

S66 NMS Call Messages 0 0=Call Connect & Progress; 1=Disable;

2=Call Connect Only; 3=Call Progress Only

S69 Make Busy Via DTR 0 0=Disable; 1=Enable

S74 Network Position 0 0=Tributary; 1=Control

S75 Network Management Address 255 0–255 (001–256)

S76 Dial Autorate 0 0=Enable; 1=Disable; 2=Start at 4800;

3=Start at 9600

S77 DTR Alarm Reporting 0 0=Disable; 1=Enable

S78 Dial Automode 0 0=Enable; 1=Disable; 2=System85

S80 No Data Disc Trigger Signal 3 0=RX or TX; 1=TX; 2=RX; 3=TX and RX

S82 Leased Autorate 0 0=Enable; 1=Disable

S84 AT Command Mode 0 0=Normal; 1=No Error; 2=No Strap or ERROR

S85 Fast Disconnect 0 0=Disable; 1=Enable

S88 Straps When Disconnected 0 0=No Change; 1=Reload; 2=Reload, No Change

S89 V.42 ARQ Window Size Increase 0 0(6 frames) – 9(15 frames)

S90 DTE Rate = VF Rate 0 0=Disable; 1=Enable

S91 Cellular Enhancement (if ETC installed) 0 0=Disable; 1=Enable

S93 RJ11 Cellular Adapt (if ETC installed) 0 0=Disable; 1=Enable