User`s guide

S-REGISTERS (continued)

S43 Train Time 0 0=Long; 1=Short

S44 Leased-Line Rate 27 1=14400(V.32bis); 2=12000(V.32bis);

3=9600(V.32bis); 4=7200(V.32bis);

5=4800(V.32bis); 6=2400(V22bis);

18=19200(V.32terbo); 19=16800(V.32terbo);

25=33600(V.34); 26=31200(V.34);

27=28800(V.34); 28=26400(V.34);

29=24000(V.34); 30=21600(V.34);

31=19200(V.34); 32=16800(V.34);

33=14400(V.34); 34=12000(V.34);

35=9600(V.34); 36=7200(V.34); 37=4800(V.34);

38=2400(V.34)

S45 Leased TX Level 0 0dBm–15dBm

S46 Auto Dial Backup 0 0=Disable; 1=Enable

S47 Auto Dial Standby 0 0=Disable; 1=15 minutes; 2=1 hour; 3=4 hours;

255=Test(2min)

S48 Leased-Line Carrier On Level 0 0=–43dBm; 1=–26dBm

S49 Buffer Disconnect Delay 10 0=Disable or 1–255 in 1-second increments

S51 DTE RL (CT140) 0 0=Disable; 1=Enable

S52 DTE LL (CT141) 0 0=Disable; 1=Enable

S53 V.54 Address 0 0(Disable) or 1–34

S54 V.54 Device Type 0 0=Peripheral; 1=Intermediate

S55 Access from Remote 0 0=Enable; 1=Disable

S56 Remote Access Password 00 00–99

1st and 2nd digits

S57 Remote Access Password 00 00–99

3rd and 4th digits

S58 Remote Access Password 00 00–99

5th and 6th digits

S59 Remote Access Password 00 00–99

7th and 8th digits

S61 CT111 Rate Control 0 0=Ignore; 1=Fallback 1; 2=Fallback 2

S62 V.25bis Coding 0 0=ASCII; 1=EBCDIC

S63 V.25bis Idle Character 0 0=Mark; 1=Flag

S64 V.25bis New Line Character 0 0=CR+LF; 1=CR; 2=LF

S66 NMS Call Messages 0 0=Call Connect & Progress; 1=Disable;

2=Call Connect Only; 3=Call Progress Only

S67 Directory Location 1 Callback 0 0=Disable; 1=Enable

S69 Make Busy Via DTR 0 0=Disable; 1=Enable

S74 Network Position 0 0=Tributary; 1=Control

S75 Network Management Address 255 0–255 (001–256)

S76 Dial Autorate 0 0=Enable; 1=Disable; 2=Start at 4800;

3=Start at 9600