Specifications

18 12000E IP Broadband Loop Carrier Installation Instructions IPD1-A2-ZZ40-20
Configuration and Management
Although no configuration is necessary to run subscriber lines at the default
settings, all 12000E parameter settings are software selectable via Command
Line Interface (CLI), Simple Network Management Protocol (SNMP), or the
Network Management System (NMS), depending upon the capabilities of the
management module model installed in your chassis. Once the management
module has been initialized, interface modules may be configured as desired
via whichever system(s) your management module is capable of running.
Refer to the following documentation for further information:
Table 1: User Documentation
Document Contents
Management module
installation instructions
(model-specific)
z module installation
port pinouts
parameter defaults
parameter configuration options
management system capabilities
Uplink module
installation instructions
(model-specific)
z module installation
port pinouts
parameter defaults
parameter configuration options
Interface module user
guides
(model-specific)
z module installation
distance and bandwidth capabilities
port pinouts
parameter defaults
parameter configuration options
CLI Management User
Guide
z management module initialization
instructions
command user guide
command definitions
configuration options common to all
management module models
configuration options common to all
interface module models
NMS Management User
Guide
z management module initialization
instructions
screen by screen user guide
parameter definitions
configuration options common to all
management module models
configuration options common to all
interface module models