Specifications

14 12000E IP Broadband Loop Carrier Installation Instructions IPD1-A2-ZZ40-20
7 Verify the connection. Turn your power source(s) on. The PWR (power)
LED on the interface module and management module faceplates will
illuminate solid green to indicate the modules are receiving power.
Establishing Your Uplink Connections
No configuration is necessary for Uplink Interface Modules (UIMs) or Media
Interface Modules (MIMs) installed on the management module(s) in your
12000E to operate at default settings. However, if you wish to run your uplink
connections at settings other than the UIM or MIM defaults, configure the
UIM or MIM prior to connection.
For further connection and configuration information, refer to the installation
instructions of your particular UIM or MIM.
05-17813
PWR
Power LED
MULTIPLEXER
UPLINK
MODULE
FAN
PWR
Lnk
Act
Dplx
T1
INVERSE
MULTIPLEXER
Management
Module
Interface
Module
05-17814
1 2 3 4 5 6 7 8 9 10 11 12 U1 U2
12000E
MUM
PWR
TIM
Uplink
Module
MULTIPLEXER
UPLINK
MODULE
FAN
PWR
Lnk
Act
Dplx