Specifications

Powering Up Your 12000E
IPD1-A2-ZZ40-20 12000E IP Broadband Loop Carrier Installation Instructions
11
3 Slide the interface module firmly into the chassis. Tighten the fastening
screws on the interface module faceplate.
Powering Up Your 12000E
CAUTION:
Turn your DC power source(s) OFF until you have completed connection
of the 12000E as outlined in the following sections.
Do not operate the 12000E without a ground connection.
1 Connect a ground wire to the 12000E: Line up the 2-hole terminal lug of
your ground wire with the two holes on the small, unpainted section on
the back of your chassis. Secure the terminal lug to the chassis with two
#10-32 screws.
05-17807
1 2 3 4 5 6 7 8 9 10 11 12 U1 U2
12000E
MUM
PWR
TIM
Fastening Screws
05-17808
 48V
30A
 48V
30A
12B 11B 10B 9B 8B 7B 6B 5B 4B 3B 2B 1B
12A 11A 10A 9A 8A 7A 6A 5A 4A 3A 2A 1A
Ground Connection
for 2-Hole Terminal Lug
12000E Rear View