user manual

Zhone Technologies / A-19
Alphabetical Reference Parameter reference
SCHAN
Specifies the first T1 time slot that data from the data port will be mapped.
Configuration group: DPCFG
Syntax:
(GET/SET) DPCFG:SCHAN:1:(1-24)
SES
SES (severely errored second): indicates the total number of seconds in which the bit error rate
exceeded one bit per thousand (1 x 10-3)
.
Configuration group: MCUR, PMTOT, PMINT, FARPMCUR,FARPMTOT, FARPMINT
Syntax:
GET (PMCUR, PMTOT, FARPMCUR, FARPMTOT):SES:x
Syntax: GET (PMINT, FARPMINT):SES:x:(0-95)
SLIP
SLIP: (slipped second): indicates the total number of seconds that contain one or more
controlled slips. A controlled slip is the deletion or replication of a T1 or E1 frame by the
receiving equipment.
Configuration group: PMCUR, PMTOT, PMINT, FARPMCUR,FARPMTOT, FARPMINT
Syntax:
GET (PMCUR, PMTOT, FARPMCUR, FARPMTOT):SLIP:x
Syntax: GET (PMINT, FARPMINT):LOFC:SLIP:x:(0-95)
STATE (V.35)
State of V.35 ports. Possible values are:
• ACTV
• STDBY (default): Unassigned should be channels be set to STDBY.
Note that the V.35 port must be set to STDBY while you are making configuration changes to
the WAN, SCHAN, or NCHAN parameters. After setting the parameters, set the STATE to
ACTIVE.
Configuration group: DPCFG
Syntax:
(GET/SET) DPCFG:STATE:1:(ACTV/STDBY)