user manual

Zhone Technologies / 4-1
Configuring the Z-Plex Using the command line interface
Chapter 4
Configuring the Z-Plex
In this chapter you will learn how to configure the Z-Plex unit using the CLI. It includes the
following topics:
Using the command line interface page 4-1
Quick start system configuration page 4-2
Configuring SNMP page 4-6
Configuring T1 interfaces page 4-7
Configuring a T1 drop and insert interface page 4-8
Configuring FXS ports page 4-8
Configuring FXO ports page 4-9
Configuring the V.35 data port page 4-10
Adding and deleting routes page 4-11
System maintenance commands page 4-15
4.1 Using the command line interface
The CLI commands use the following format:
SET group:parameter:index:value to change the value of a read/write parameters.
GET group:parameter:index:value for read-only parameters or to view the current
configuration of a parameter without making any changes.
• group identifies the configuration grouping of the parameter. For example, T1CFG.
• parameter identifies the actual configuration element. For example, FRAME.
• index identifies the physical index of the element you want to configure. Most elements
have an index of 1. T1 lines have 2 indexes, which correspond to the 2 WAN interfaces.
For example, to activate the first T1 line, enter the following command: