User Manual

Balance Adjustment

To facilitate the adjustment procedure, we recommend locking the three

axes of WEEBILL LAB the way as camera-mounted state, then unlock and

make balance adjustment of the axes one by one.

❶

Unlock the tilt axis and the camera locking

latch, push the camera to move forward or

backward until the camera can stay still and

almost level with its lens facing front (as

shown on the right). Complete this step by

tightening up the camera mounting thumb

screw.

❷

Make the lens face up, slightly loosen the

thumb screw of the tilt axis, push the camera

to move upward or downward until the

camera can stay still with the lens facing up

(i.e.the camera stays still and vertical to the

ground as shown on the right). Complete this

step by tightening up the thumb screw.

❸

Unlock the roll axis, slightly loosen the

thumb screw at the bottom of the quick

release plate, push the camera to move left

or right until the camera can stay still and

horizontal to the ground (as shown on the

right). Complete this step by tightening up

thumb screw.

Balance Adjustment

Push the safety lock up if it stucks.