User's Manual

2
3. Installation
The positioning hole distance of the boundary manager is rectangular 82mmx141mm.
The boundary manager is powered by POE. If POE is used, the communication
gateway needs to support the POE function. The boundary manager needs to test
the communication distance to determine the ideal installation position. It can also
be installed against the wall. Notice that there must be no metal shields around the
installation, otherwise it will affect the wireless reception effect. After the power is
turned on, the working green light flashes at intervals.
Optional wiring installation of acousto-optic access control, as shown in Figure 2
interface. 1 port is connected to the red positive pole of sound and light, and 2 port
is connected to the black negative pole of sound and light. 3 port is connected to the
negative pole of the access control, and 4 port are connected to the positive pole of
the access control. The DC power connector is left unused. The network interface is
connected to the POE switch. At the same time, the positioning distance adjustment
interface is an optional distance, the side closest to the network port is the farthest
distance, and the rear decreases in turn.
4. Instructions
After the boundary manager is installed and powered on, you could check whether
the device is normal through the work indicator (as shown in Figure 1). During
normal operation, the green light flashes once every 1 second,and the red light
flashes once to indicate that a frame of correct RFID information has been received.
Positioning function, When there are assets or personnel passing through the area
managed by the border manager, the positioning signal will be sent out inside the
device. And when the device senses the positioning signal from tag , the positioning
information will be uploaded.
5. Precaution
1. It is strictly forbidden to install the equipment in an environment with high
temperature, dust, harmful gas, flammable, explosive, susceptible to
electromagnetic interference, unstable voltage and large vibration.
2. The installation location need to be as concealed as possible, so as not to hinder
daily work and life.
3. The POE power supply is DC48V.