Quick Start Guide
Table Of Contents
USB Type C Port
For Manual Updates
Maintenance
Software Updates
ProCure 2 will periodically receive updates over the air via wireless network.
Ensure ProCure 2 is connected to the internet to receive updates.
Troubleshooting
Please call customer support to perform advanced troubleshooting. A USB cable
with a type C adapter is provided to connect ProCure 2 to your computer if needed.
7
Warning:
Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.
FCC Statement:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and,
if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
Please make sure that the product is normally connected to the wifi network during use, and the contact voltage is good during use. In order to have a good
experience of using the product, please keep at least 20 cm when working.