User's Manual

No Signal screen is displayed when th D-Sub
signal connector is not connected or the status of
the monitor is on DPMS mode.
Out of Range screen is displayed when the
applied frequency is under or over normal range.
Adjust the pin corner top when the top
sides of the screen are bowed.
T. PIN CORNER
English - 9
SPECIFICATIONS
English - 8
Display horizontal & vertical frequency
and polarity.
Degaussing keeps the monitor free from
unwanted magnetism that can result in
color impurity.
DEGAUSS
STATUS
ICON CONTROL FUNCTION
Normal range
H : 30 - 95 KHz
V : 50 - 160 Hz
Self Diagnosis
When the monitor doesn’t display, if you press any key, Self Diagnosis
screen is displayed. Self Diagnosis function checks if the status of the
monitor is No Signal or Out of range.
Adjust the pin corner bottom when the
bottom sides of the screen are bowed.
B. PIN CORNER
Adjust the rotation when the screen is
tilted left or right.
ROTATION
COLOR TEST
Display a RGB Color Bar to determine
whether the screen color is expressed
normally or not.
Model Names 940DF 940DFBK
Mode H.Freq (KHz) V.Freq(Hz) Remark
VGA 480 640
X 480 31.5 60 Non-interlaced
VGA 400 720
X 400 31.3 70 Non-interlaced
VESA 43K 640
X 480 43.3 85 Non-interlaced
VESA SVGA 85 800
X 600 53.7 85 Non-interlaced
VESA 60K 1024
X 768 60.0 75 Non-interlaced
VESA 1024/85 1024
X 768 68.7 85 Non-interlaced
VESA 1280/75 1280
X 1024 80.0 75 Non-interlaced
VESA 1280/85 1280
X 1024 91.1 85 Non-interlaced
Resolution
(dots
X lines)
CDT Size 19-inchFlat 19-inch Flat
Diagonal visible image area 18-inch 18-inch
Dot Pitch 0.24 mm 0.24 mm
Synchronization Horizontal 30 - 95 KHz
Vertical 50 - 160 Hz
Plug and Play VESA DDC Compatible
Power Saving EPA, VESA DPMS, Nutek Compliant
Power Source 100 - 240 Vac, 50/60 Hz (Free Voltage)
Power Consumption 100W
Dimension-W x H x D 444 x 442 x 458 mm 444 x 442 x 458 mm
(set with stand)
Weight-unpacked(lbs/Kg) 45.6/20.7 45.6/20.7
Operating Temperature 10 ~ 40°C /50 ~ 104°F
The specification can be changed without any prior notice to improve
the quality of the product.
FACTORY PRESET TIMINGS
Video input signal voltage varies dependent
on a video card. Please change the signal
voltage if images run on the monitor. (The
factory default is 0.7V)
SIGNAL LEVEL
Reset the screen to the Factory Preset
Display Settings.
RECALL