USER’S GUIDE GUIDE USER’S COLOR MONITOR Model No : C940DF/C940DFBK
IMPORTANT SAFEGUARDS 1. Read all of these instructions. 2. Save these instructions for later use. 3. Unplug this monitor from the wall outlet before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for cleaning. 4. Do not use attachments not recommended by the monitor manufacturer as they may cause hazards. 5. Do not use this monitor near water, e.g., near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. 6.
WICHTIGE INFORMATIONEN Bitte lesen Sie alle diese Informationen, bevor Sie das Gerät in Betrieb nehmen! Lesen Sie sich außerdem die Bedienungsanleitung komplett und sorgfältig durch, da nur in diesem Fall eine problemlose Inbetriebnahme erwartet werden kann. • Achten Sie darauf, daß das Gerät nur in eine 230V Schuko-Steckdose eingesteckt wird. • Die Steckdose sollte jederzeit frei zugänglich sein um bei einem evtl. auftretenden Notfall das Gerät schnell vom Netz zu trennen.
CONTENTS Introduction ............................................................................. 1 Product Features ................................................................. 2 Setup ......................................................................................... 3 Installing the Tilt/Swivel Stand .......................................... 3 Connecting the Signal Cable and Power Cord..................... 4 Operation & Adjustment ......................................................
SETUP PRODUCT FEATURES • The convenient and user-friendly on-screen display allows for easy and accurate adjustments of horizontal and vertical screen size and position, geometry, and screen color. INSTALLING THE TILT/SWIVEL STAND 1. Ensure that the power is off to the monitor. • The monitor complies with the VESA Display Data Channel (DDC) specification for Plug and Play compatibility. Advanced microcircuitry makes setup and configuration fast and effortless. 2.
CONNECTING THE SIGNAL CABLE AND POWER CORD OPERATION & ADJUSTMENT Control Panel 1. Turn off the computer and monitor. 1 POWER 2 POWER Indicator shows both normal operation and power management status with power indicator light. swithes the monitor on and off. 2. Connect the 15 pin D-sub connector to the output port of the video card in your computer. 3. Tighten the screws of the connector. 2 1 4. Plug the power cord into the AC receptacle located on the back of the monitor. 5.
Key Process OSD Functions ICON CONTROL FUNCTION LANGUAGE Select language for OSD (5 languages). H. CENTER & Adjust the position of the display horizontally (left or right) and vertically (up or down). V. CENTER • When you choose the icon exit the OSD screen. on the OSD window, you can Hot Key COLOR TEMP Choose different preset color temperatures or set your own customized color parameters. RED GAIN Adjust the red gain. GREEN GAIN Adjust the green gain. BLUE GAIN Adjust the blue gain. H.
SPECIFICATIONS Model Names ICON CONTROL FUNCTION T. PIN CORNER Adjust the pin corner top when the top sides of the screen are bowed. B. PIN CORNER Adjust the pin corner bottom when the ROTATION bottom sides of the screen are bowed. Adjust the rotation when the screen is tilted left or right. Degaussing keeps the monitor free from unwanted magnetism that can result in color impurity. Display horizontal & vertical frequency STATUS and polarity.
TROUBLESHOOTING Symptom No picture. Check Check if power switch and computer power switch are in the on position. Check if the signal cable is correctly connected to the video card. Check if the pins of D subconnector are not bent. Check if the computer is in the power- saving mode. POWER LED is not Check if power switch is in the on position. lit. Check if the power cord is correctly connected. Image is unstable. Check if the signal cable is suitable to the video card.
S/N:XL78600800