User's Manual
Initial TV Setup
After you have initially connected your TV antenna or cable (no set top box) turn the television ON. A screen will display asking you to run a
Channel Auto Scan to search and receive available local digital channels. It is here where you will select antenna options and run Channel
Auto Scan. Channels will be stored in the TV tuner.
Press the MENU button on the remote control.
Using the WX arrow buttons, scroll to highlight TV mode.
Press the down T arrow button to highlight AIR/CABLE
How to Navigate:
.
Select AIR when connected
to an indoor/outdoor
antenna.
Press the WX arrow
button to highlight AIR
Press the down T arrow
button to select Auto Scan
then press the X right arrow
button to start Channel Auto
Scan.
&KDQQHO$XWR6FDQ may
take several minutes to
complete.
Select CABLE if you subscribe
to a pay television service includ-
ing satellite.
Using the WX arrow button to
highlight CABLE
3UHVVWKH T arrow button
to select AUTO SCAN. Press
ENTER and the cursor will move
up and CABLE SYSTEM will be
displayed next.
3UHVVWKH X arrow button to
select STD > IRC > HRC > Auto
(Auto is recommended).
3UHVVWKHGRZQT arrow button
to select Auto Scan and press
ENTER to start Channel Auto
Scan
&KDQQHO$XWR6FDQ may take
several minutes to complete.
Air Mode Cable Mode
TV Channel Setup
& Channel Auto Scan
17
127()RUFDEOHRUVDWHOOLWH
XVHUVZLWKQR79DQWHQQD
WKHUHQRQHHGWRUXQ&KDQ
QHO$XWR6FDQ&RQQHFW
\RXUFDEOHRUVDWHOOLWHVHW
WRSER[WRRQHRIWKHDYDLO
DEOHLQSXWVRQWKH79IRU
YLHZLQJ