Quick Guide
Table Of Contents
- 1 Default IP, Username and Password
- 2 Disk Installation
- 3 (Optional) Install SD Card
- 4 Connect the Kit
- 5 Device Operation
- CAUTION!
- Do not disconnect power when the NVR is operating or shutting down.
- CAUTION!
- The NVR's wireless NIC IP must be in a different network segment with its LAN IP address.
- NOTE!
- After SSID or password are changed on the NVR, the new SSID or password will be synchronized to online cameras. For offline cameras, the changed settings cannot be synchronized, and you need to pair the camera with the NVR again. See 5.3 Pair Devices Again for details.
- NOTE!
- The following methods are also applicable if you pair a camera not in the kit with the NVR.
- NOTE!
- The reset button only works in 1-10 minutes after the camera is powered on. If you fails to press the button within the time range, you need to power off the camera and then on again to restore the defaults.
- NOTE!
- This function works within 3 minutes after the camera restores defaults. So, if the camera is not paired successfully within this time, please restart the camera or try other methods.
- 6 Install Devices
- 7 Playback
- NOTE!
- 8 EZView
- 9 Web Login
- Disclaimer and Safety Warnings
5
NOTE!
The following methods are also applicable if you pair a camera not in the kit with
the NVR.
One-Click Pair
1. Connect the camera and the NVR to the same switch (or connect the camera to
the NVR with a network cable), and connect the devices to power.
2. Right-click on the NVR and then choose Menu > Network > Wi-Fi AP.
3. Press the RESET button on the back of the camera to restore factory default
settings.
NOTE!
The
reset button only works in 1-10 minutes after the camera is powered on. I
f you
fails to press the button within the time range, you need to power off the camera
and then on again to restore the defaults.
4. Click One-Click Pair.
NOTE!
This function works
within 3 minutes after the camera restores defaults
. So, if the
camera is not paired
successfully within this time, please restart the camera or
try
other methods.
5. Wait for the camera to get online.
QR Code Pair
1. Connect the camera to power.
2. Press the RESET button on the back of the camera to restore factory default
settings.
3. Right-click on the NVR and then choose Menu > Network > Wi-Fi AP.
4. Click QR Code Pair, and follow the on-screen instructions to scan the QR code.