Quick Guide
Table Of Contents
- 1 Default IP, Username and Password
- 2 Disk Installation
- 3 (Optional) Install SD Card
- 4 Connect the Kit
- 5 Device Operation
- CAUTION!
- Do not disconnect power when the NVR is operating or shutting down.
- CAUTION!
- The NVR's wireless NIC IP must be in a different network segment with its LAN IP address.
- NOTE!
- After SSID or password are changed on the NVR, the new SSID or password will be synchronized to online cameras. For offline cameras, the changed settings cannot be synchronized, and you need to pair the camera with the NVR again. See 5.3 Pair Devices Again for details.
- NOTE!
- The following methods are also applicable if you pair a camera not in the kit with the NVR.
- NOTE!
- The reset button only works in 1-10 minutes after the camera is powered on. If you fails to press the button within the time range, you need to power off the camera and then on again to restore the defaults.
- NOTE!
- This function works within 3 minutes after the camera restores defaults. So, if the camera is not paired successfully within this time, please restart the camera or try other methods.
- 6 Install Devices
- 7 Playback
- NOTE!
- 8 EZView
- 9 Web Login
- Disclaimer and Safety Warnings
4
Password: The default is the last eight digits of the serial number. You are strongly
recommended to change into a strong password.
Region, Channel: Signal interference varies with region and channel. You are
recommended to choose a channel with less signal interference.
Wireless NIC IP: The IP address of wireless NIC. The NVR assigns IP address to
connected devices based on the start and end IP address range.
CAUTION!
The
NVR's wireless NIC IP must be in a different network segment with its LAN
IP
address.
3. Click Apply.
NOTE!
After
SSID or password are changed on the NVR, the
new SSID or password will be
synchronized to online cameras. For offline cameras, the changed settings cannot
be
synchronized, and you need to pair the camera with the NVR again. See 5.3
Pair
Devices Again for details.
5.3 Pair Devices Again
If you change Wi-Fi settings on the NVR when cameras are offline, you need to pair
devices again. Choose one of the following methods as needed.