Quick Guide

7
Mount the cover.
Secure the cover by fastening the three
screws using a Phillips screwdriver.
Use a T10 star wrench to unscrew the
two tamper proof screws that fix the
card module on both sides of the
terminal.
Fasten the access control terminal to the
bracket hook.
Use a T10 star wrench to tighten the
two tamper proof screws.
4 Startup
After the terminal is installed correctly, connect one end of the power adapter
(purchased or prepared separately) to the mains supply and the other end to the
power interface of the terminal, and then start it up. The display screen of the door
station lights up, and live view is displayed on the terminal screen when the terminal
is started successfully.
Secure the
screws with
screwdriver.
Tamper proof
screw
Interference fit
allows screw to
be loosened
but not fall off.
Tighten the screws