Quick Guide

6
Paste the template.
• With junction box: Align the two holes (A) on the drill template with the two
installation holes on the junction box. See the left figure below.
• Without junction box: Paste the drill
template on the wall with the arrow
perpendicular to the ground. Use a Ø6-6.5mm drill bit to drill three 30 mm-depth
holes on the A position (be careful not to damage cables in the wall), then insert
expansion bolts. See the right figure below.
（With junction box） （Without junction box）
Mount the bracket.
Align bracket holes with installation holes of the junction box on the wall, and tighten
the screws to fasten the bracket by using the Phillips screwdriver.
Note:
If no junction box, you need to drill the bracket holes on the wall when installation.
Reference line
The square hole is a leading-out hole.
Holes A are fixing holes on the wall.
It is recommended that the distance from the ground be (51.18 inch) 1.3
m and the distance can be adjusted based on the body hei ght.
up
墙体
Reference line
The square hole is a leading-out hole.
Holes A are fixing holes on the wall.
It is recommended that the distance from the ground be (51.18 inch) 1.3
m and the distance can be adjusted based on the body hei ght.
up
墙体
Align hole A with
the installation
holes on the
junction box.
Wall
Wall