Quick Guide

11
installation is adopted, cables are not penetrated into
the wall but threaded out from the outlet on one side
of the base.
Access Your Camera
Before you begin, check that:
⚫ Your camera is operating properly and connected to the
network.
⚫ The PC you are using is installed with Internet Explorer
7.0 or later.
Follow these steps to access your camera through the Web:
Open your browser, input the IP address of your camera in
the address bar and then press Enter to open the login page.
Enter the username and password and then click Login.
⚫ Install the ActiveX at your first login. When the
installation of the ActiveX is completed, open your
IE to log in.
⚫ For your first login with Windows 7, if the system
does not prompt you to install ActiveX, follow these
steps to turn off UAC: click the Start button, and
then click Control Panel. In the search box, type
uac, and then click Change User Account Control
Settings. Move the slider to the Never Notify
position, and then click OK. After UAC is turned off,
log in again.