Quick Guide

1
Safety and Compliance Information
Installation and removal of the unit and its accessories must be carried
out by qualified personnel. You must read all of the Safety Instructions
supplied with your equipment before installation and operation.
Installation
 This device is a class A product and may cause radio interference.
Take measures if necessary.
 Make sure the camera operates in an environment where the
temperature and humidity meet requirements. Keep the camera
from excessive pressure, vibration, moisture, dust, and intensive
electromagnetic radiation.
 Use a power adapter or a PoE device that meets requirements.
Otherwise, the device may be damaged.
 Make sure the length of the power cable between the power
adapter and the camera is not too long, otherwise the voltage of
the camera is lowered, causing the camera to work abnormally. If it
is required to lengthen the power cable, lengthen the cable
between the power adapter and the mains.
 Do not hold the tail cable by hand for weight bearing. Otherwise,
the cable connector of the camera could be loosened.
 When connecting to an external interface, use an existing
connection terminal, and ensure that the cable terminal (latch or
clamp) is in good condition and properly fastened. Ensure that the
cable is not tense during mounting, with a proper margin reserved
to avoid poor port contact or loosening caused by shock or shake.
 During the process of transportation, special attention is required
for the protection of the glass window to prevent friction, scratch
and contamination, etc. In order to keep the cover clean, do not
remove the protective film on the cover during mounting. After
mounting is finished, remove the film before the device is powered
on.