User's Manual

IMPORTANT SAFETY INSTRUCTIONS
• Read and keep these safety instructions.
• Heed all warnings contained within these instructions.
• Please follow all user manual instructions when installing the product.
• Only clean Sengled product only with a dry towel.
• This Product is intended for indoor use only.
• Do NOT use this product outdoors.
• Do NOT get this product wet and do NOT use near any water source.
• The product should not be exposed to dripping or splashing liquids of any kind.
• Do not install the product near any heat sources, such as heater, radiators, stove,
heat registers or other apparatus that produce heat.
• Ensure that the product is stable and secured in place during installation. If the
product is dropped or falls out of the light socket, it may cause bodily harm.
• If the product is dropped or falls out of the light socket, it may be damaged. Please
check the product for any visible damage.
• To reduce the risk of electric shock, do NOT remove the back cover or take apart.
There are no serviceable parts inside.
• To prevent product failure, the bulb should only be installed in operating
environments ranging between +32 degrees Fahrenheit and +95 degrees Fahrenheit
(0 degrees Celsius and +35 degrees Celsius).
• Do not block any ventilation openings on the product, as shown below.
• Never push any objects into the openings or slots on the product. Doing so may
create an electric shock or fire hazard.
• Maintain sufficient distance around your product for sufficient ventilation; do not
put anything within at least 6 inches of light bulb socket.
• For best protection against lightning, unscrew the product from its power source
during a storm.
• Only use accessories specifically recommended by the manufacturer.
• Refer all servicing to qualified Sengled service technician.
• Servicing is required when the product:
1) Has been damaged in any way;
2) Liquid has been spilled on the product;
3) Objects have fallen into the product;
4) The product has been exposed to rain or moisture,
5) The product does not operate normally, or has been dropped.
• Repairs must be performed by a qualified Sengled technician.
• For bulbs with a weight significantly higher than the bulbs for which they are a
replacement, the increased weight may reduce the mechanical stability of certain
luminaires and bulb holders and this may impair contact and bulb retention. Check
all sockets and bulb holders frequently and make sure they are secure and stable.
• The bulb can be hot and should not be touched without taking care.