Data Sheet
Table Of Contents
- 1. Product Introduction
- 1.1 Introduction
- 1.2 Application
- 1.3 Main Characteristics
- 1.4 Product Advantage
- 1.5 Abbreviations
- 1.6 Related Documents
- 2. Product Overview
- 2.1 Overview
- 3. Technical Specification
- 3.1. Electrical Specification
- 3.2. Physical/Ambient Characteristics
- 3.3. Pin Configuration
- 3.4 Antenna Specification
- 3.5. RF Performance
- 3.6. Soldering Temperature for Module
- 3.7. Packing
- 4. Ordering Information
23
and the ISED cannot be used on the final product. In these circumstances, the OEM integrator will
be responsible for re-evaluating the end product (including the transmitter) and obtaining a
separate Canada authorization.
Any company of the host device which install this modular with limit modular approval should
perform the test of radiated emission and spurious emission according to RSS-247 and RSSGen
requirement, only if the test result comply with RSS-247 and RSS-Gen requirement, then the host
can be sold legally.
Note Importante :
Dans le cas où ces conditions ne peuvent être satisfaites (par exemple pour certaines
configurations d'ordinateur portable ou de certaines co-localisation avec un autre émetteur),
l'autorisation du Canada n'est plus considéré comme valide et l' ISED ne peut pas être utilisé sur le
produit final. Dans ces circonstances, l'intégrateur OEM sera chargé de réévaluer le produit final (y
compris l'émetteur) et l'obtention d'une autorisation distincte au Canada. toute entreprise de
l'hôte qui installent ce dispositif modulaire avec limite approbation devrait effectuer l'essai des
modules et des rayonnements non essentiels des émissions rayonnées selon rss-247 et le cnr -
gen, seulement si le résultat d'essai conforme rss-247 et le cnr - gen, puis l'hôte peut être vendu
légalement.
End Product Labeling
The final end product must be labeled in a visible area with the following: Contains