Data Sheet
Table Of Contents
- 1. Product Introduction
- 1.1 Introduction
- 1.2 Application
- 1.3 Main Characteristics
- 1.4 Product Advantage
- 1.5 Abbreviations
- 1.6 Related Documents
- 2. Product Overview
- 2.1 Overview
- 3. Technical Specification
- 3.1. Electrical Specification
- 3.2. Physical/Ambient Characteristics
- 3.3. Pin Configuration
- 3.4 Antenna Specification
- 3.5. RF Performance
- 3.6. Soldering Temperature for Module
- 3.7. Packing
- 4. Ordering Information
22
Commission to operate with the antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain greater than the maximum gain
indicated for any type listed are strictly prohibited for use with this device.
2.8 Label and compliance information
The final end product must be labeled in a visible area with the following " Contains
FCCID:2AOE2-REX3B21”
2.9 Information on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance with FCC requirements for
the transmitter when the module is installed in the host.
2.10 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host system with module installed with all
other applicable requirements for the system such as Part 15 B.
ISED Important Note:
In
the event that these conditions cannot be met (for example certain laptop configurations or
co-location with another transmitter), then the Canada authorization is no longer considered valid