Data Sheet
Table Of Contents
- 1. Product Introduction
- 1.1 Introduction
- 1.2 Application
- 1.3 Main Characteristics
- 1.4 Product Advantage
- 1.5 Abbreviations
- 1.6 Related Documents
- 2. Product Overview
- 2.1 Overview
- 3. Technical Specification
- 3.1. Electrical Specification
- 3.2. Physical/Ambient Characteristics
- 3.3. Pin Configuration
- 3.4 Antenna Specification
- 3.5. RF Performance
- 3.6. Soldering Temperature for Module
- 3.7. Packing
- 4. Ordering Information
20
applicables aux appareils radio exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est
susceptible d'en compromettre le fonctionnement.
ISEDC Radiation Exposure Statement:
This equipment complies with ISEDC RF radiation exposure limits set forth for an uncontrolled
environment.
This transmitter must not be co‐located or operating in conjunction with any other antenna or
transmitter.
IC exposition aux radiations:
Cet équipement est conforme avec ISEDC les limites d'exposition aux rayonnements définies pour
un
contrôlé environnement.
Cet émetteur ne doit pas être co‐localisés ou fonctionner en conjonction avec une autre antenne
ou émetteur.
Any changes or modifications not expressly approved by the party responsible for compliance
could void the
user’s authority to operate the equipment.
Tous les changements ou modifications non expressément approuvée par le responsible de la
conformité
pourrait vider l’utilisateur est habilité à exploiter l’équipemen.
If the FCC identification number is not visible when the module is installed inside another device,
then the outside of the device into which the module is installed must also display a label referring
to the enclosed module. This exterior label can use wording such as the following: “Contains
Transmitter Module FCC ID: 2AOE2-REX3B21 or Contains FCC ID: 2AOE2-REX3B21”
The outside of final products that contains this module device must display a label referring to the
enclosed module. This exterior label can use wording such as:
“Contains Transmitter Module IC: 22670-REX3B21”,or “Contains IC: 22670-REX3B21”, Any
similar wording that expresses the same meaning may be used
Instructions d'étiquetage IC: L'extérieur des produits finis contenant ce module doit afficher une
étiquette faisant référence au module inclus. Cette étiquette extérieure peut utiliser des libellés
tels que: contient le module émetteur IC: 22670-REX3B21”ou“ contient: IC: 22670-REX3B21 ”,
tout libellé similaire exprimant le même sens peut être utilisé