Manualshelf

Data Sheet

ManualsBrandsZhejiang Rexense IoT Technology ManualsElectronicsZigbee Module
12345678910
- 3 -
HVAC monitoring and control
Inventory Management
Smart Agriculture
Industrial Monitoring
Smart Traffic
Automatical Meter Reading
FCC ID: 2AOE23BV3
Host labeling requirement: Contains FCC ID：2AOE23BV3
The single-modular transmitter is a self-contained, physically delineated, component for which
compliance can be demonstrated independent of the host operating conditions, and which
complies with all eight requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired
operation.
Please note that changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
Note: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
—Consult the dealer or an experienced radio/TV technician for help.
This equipment complies with radio frequency exposure limits set forth by the FCC for an
uncontrolled environment.
This equipment should be installed and operated with a minimum distance of 20 cm between the
device and the user or bystanders.
This device must not be co-located or operating in conjunction with any other antenna or
transmitter.