User's Manual
Table Of Contents
- 1. Introduction
- 2. Product Overview
- 3. Specifications
- 3.1 General Specifications
- 3.2 LTE Specifications
- 3.3 GPS Specifications
- 3.4 BLE Specifications
- 3.6 Other Specifications
- 4. Interface Description
- 4.1 Connector Interface
- 5. User Instructions
- 5.1 Installing SIM Card
- 5.2 Installing ZK200MGU to the RTK
- 5.3 Communicating with Backend Server
- 5.4 Debugging
- 5.5 Warning
- 5.6 Radiation Exposure Statement
- 5.5 CE Declaration
ZK200MGU User Manual
5.3 Communicating with Backend Server
After installing SIM card and powered on, ZK200MGU can communicate with the backend server through network,
and transfer reports of emergency, Geo-fencing, device status and scheduled GPS position etc. It is easy for
service provider to set up their tracking platform based on the functional wireless tracking protocol.
5.4 Debugging
Users can use the 4-pin interface to give commands to the device locally for the purpose of testing and
debugging.
5.5
WARNING
Pay attention to any warnings.
Do not attempt to open or disassemble GPS Tracker.
Do not place GPS Tracker on or in heating devices, such as heaters, fire source etc.
Do not expose GPS Tracker to extreme temperatures. The recommended temperature ranges are from
-20℃
~+60℃
.
Do not place GPS Tracker close or dispose to fire. This may cause the device to explode.
5.6
RADIATION EXPOSURE STATEMENT
This equipment should be installed and operated with minimum distance 20cm away from your body.
5.5 CE Declaration
Hereby, Zhejiang Okai Vehicle Co., Ltd. declares that the radio equipment type GPS tracker ZK200MGU is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
https://www.okai.co/