ZK115M User Manual GPS Tracker
ZK115M User Manual 1. Introduction The ZK115M is a water‐resistant GPS tracker designed for scooter. its built‐in GPS receiver has superior sensitivity and fast time to first fix (TTFF). Its LTE allows the ZK10M's location to be monitored in real time or periodically tracked by a backend server or other specified terminals. its built‐in 3‐axis accelerometer allows motion detection and extends battery life through sophisticated power management algorithms.
ZK115M User Manual B2/B4/B5/B12/B13/B25/B66/B71/B85 GSM:GSM850/GSM1900 GPRS: Max. 107Kbps (DL), Max. 85.6Kbps (UL) 3 GSM Features EGPRS: Max. 296Kbps (DL), Max. 236.8Kbps (UL) Support LTE Cat.M1 and LTE Cat.NB2 4 LTE Features Cat.M1: Max. 588kbps (DL)/1119kbps (UL) Cat.NB2: Max.127kbps (DL)/158.5kbps (UL) 5 Transmit Mode TCP, UDP, SMS 3.3 GPS Specifications No.
ZK115M User Manual 3.4 BLE Specifications No. Item Parameters 1 Antenna Internal only 2 Frequency 2.4GHz RF transceiver compatible with Bluetooth low Energy (BLE) 3 Sensitivity Excellent receiver sensitivity ‐88dBm 4 Max out RF Power -7.54 dBm 3.5 NFC Specifications No. Item Parameters 1 Antenna Internal only 2 Frequency 13.56 MHz. Full NFC controller solution 3.6 Other Specifications No.
ZK115M User Manual 4. Interface Description 4.1 5‐pin Connector Interface Pin No. Pin Name Description 1 GND Power GND (Black) 2 CAN‐ON Control signal output (Blue) 3 CAN‐H CAN Bus H Line (Green) 4 CAN‐L CAN Bus L Line (Yellow) 5 DC IN: 12V Power+ Input (Red) 4.2 4‐Pin Connector Interface Pin No. Pin Name Description 1 OUT_3V Voltage output pin: 3.0V, 150mA (Red) 2 UART RX UART debug port (Orange) 3 UART TX UART debug port (Brown) 4 GND GND (Gray) 5. User Instructions 5.
ZK115M User Manual 2, Open ZK115M and insert SIM card as follows. 5.2 Installing ZK115M to the Scooter Connect the 5‐pin interface to the scooter, and then it will be powered on and can communicate with the scooter. ZK115M can report the position and status of the scooter to the backend server and the backend sever can send commands to ZK115M to transfer to scooter to control the behavior of the scooter also. 5.
6 BLE 6.1 BLE working modeexplanation ZK115M isinstalled in the SharedScooter and supplied by the main battery of Scooter. With the external power(main battery of Scooter) supplying , the BLE of ZK115M works. Otherwise with the backup battery of ZK115M supplying, BLE stops working. 6.2 BLE instructions Heartbeat packet uploaded from ZK115M to Server includes 20 bytes dynamic password (BLE Command Password).
FCC Statement： Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference,and (2) this device must accept any interference received, including interference that may cause undesired operation.
