User's Manual

ManualsBrandsZhejiang Okai Vehicle ManualsElectronicsMeter

500B Meter User Manual

1. GEN

ERAL INFORMATION

1.1 Product Specifications

MODEL ES500B ECU ES500BFOC

Standby Power

＜5mA

Working Voltage 42 V

Dimension 37*32*22 (mm) Working Temperature

-40℃~70℃

Head Lamps ES500B Head Lamp Acceleration Hall Acceleration

Brake Mechanical Brake Hardware Version 2020-11-27

Case Material None Software Version 516184

1.2 Ha

rness Interface

Interface Terminal Specification

Headlamp White 2-core SMfemale; red and black wire. Meter

Brake White 3-core male; red, green and black wire.

Acceleration White air docking 3-core female; red, yellow and black wire.

Communication 5-core male; red, green, blue, yellow and black wire.

Horn White 2-core female; red and black wire.

Summary of content (7 pages)

PAGE 1
ES500B Meter User Manual 1. GENERAL INFORMATION 1.1 Product Specifications MODEL ES500B ECU ES500BFOC Standby Power ＜5mA Working Voltage 42 V Dimension 37*32*22 (mm) Working Temperature -40℃~70℃ Head Lamps ES500B Head Lamp Acceleration Hall Acceleration Brake Mechanical Brake Hardware Version 2020-11-27 Case Material None Software Version 516184 1.2 Harness Interface Interface Terminal Specification Headlamp White 2-core SMfemale; red and black wire.
PAGE 2
. TECHNICAL PARAMETERS 2.1 BLE Parameters No Item Parameters 1 Antenna Internal Only 2 Chipset NRF52832 3 Frequency 2.4G RF Transceiver Compatible with Bluetooth Low Energy (BLE) 4 Sensitivity Excellent Receiver Sensitivity -90dBm 5 Max out RF Power Up to -0.26dBm 6 Antenna Gain 1dBi 2.2 Other Parameter No 1 Item Parameters MCU Core: NRF52832 Flash Memory: 512 kB Ram: 64 kB 2 3. Timing Report Reportstatus at pre-set intervals METER FUNCTION DESCRIPTION 3.
PAGE 3
according to the depth of the handle press. The lighter the press, the slower the speed, the faster the press, the faster the speed. The real-time speed is displayed in the first three words of the meter. 4 Brake The brake is electronic brake + drum brake. When the brake is pressed, the system controls the output electromagnetic brake and slows down gradually until the hub is locked. 5 Kick Start The controller can drive the motor only when the speed of the kicking is above 4 km/h or 2.5mph.
PAGE 4
mode maximum speed is 5km. It can only be started with help, not without help, and the meter flashes at the same time. 15 On/off cruise mode Configure the scooter to turn on or off the constant speed cruise mode by Bluetooth command.
PAGE 5
3.2 Error reporting Function Error Code Error Item Reasons 01E Over current protection The current exceeds the limit.
PAGE 6
3.
PAGE 7
FCC Statement Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.