User's Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Installation
- 2.1 Installation protection
- 2.2 Unpacking inspection
- 2.3 Installation of necessary equipment
- 2.4 Antenna installation
- 2.5 Gateway body installation
- 2.6 Power supply installation
- 2.7 Grounding cable installation
- 2.8 Antenna extension scheme
- 2.9 Interface waterproofing
- 2.10 Pole and wall mounting
- 2.12 Antenna replacement
- Note：Replacement step reference to 2.4 Antenna ins
- Chapter 3 Broadcast Compliance Instructions
- Chapter 4 Precautions
- Chapter 5 Troubleshooting
- Notice to Users
- Contact Information
20
IoT Interworking
Make Your Life Smart
Security Code
2.11.2 Wall mounting
Figure 13 Wall mounting fixing hole
As shown in Figure 13, the expansion screws have been tightened up for the wall according to the
hole position of the bottom plate (marked with red box), following by fixing the gateway.
2.12 Antenna replacement
LoRa antenna replacement
Antenna must satisfy some conditions:
①Antenna transmission and reception must meet the frequency range: 902-928 MHz
②Antenna impedance: 50Ω
GPS antenna replacement
Antenna must satisfy some conditions:
①Antenna transmission and reception must meet the frequency range: 1560-1575MHz
②Antenna impedance: 50Ω
Note：Replacement step reference to 2.4 Antenna installation