User's Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Installation
- 2.1 Installation protection
- 2.2 Unpacking inspection
- 2.3 Installation of necessary equipment
- 2.4 Antenna installation
- 2.5 Gateway body installation
- 2.6 Power supply installation
- 2.7 Grounding cable installation
- 2.8 Antenna extension scheme
- 2.9 Interface waterproofing
- 2.10 Pole and wall mounting
- 2.12 Antenna replacement
- Note：Replacement step reference to 2.4 Antenna ins
- Chapter 3 Broadcast Compliance Instructions
- Chapter 4 Precautions
- Chapter 5 Troubleshooting
- Notice to Users
- Contact Information
20
IoT Interworking
Make Your Life Smart
Security Code
by the antenna bottom plate and the antenna semi-circular pressure plate, with the help of expansion
screws or U-shaped hoops, as shown in Figure 10.
Note：no external amplifier can be used.
2.9 Interface waterproofing
Figure 11 interface waterproofing installation
The N-type interface of the LoRa and GPS antennas is not waterproof, so it must be protected with
waterproof tape or waterproof cold-shrink tubes when used outdoors. It is recommended to use the
cold-shrink sleeve protection interface produced by Shenzhen COTRAN New Material Co., Ltd.
2.10 Pole and wall mounting