User's Manual
Table Of Contents
- Chapter 1 Overview
- Chapter 2 Installation
- 2.1 Installation protection
- 2.2 Unpacking inspection
- 2.3 Installation of necessary equipment
- 2.4 Antenna installation
- 2.5 Gateway body installation
- 2.6 Power supply installation
- 2.7 Grounding cable installation
- 2.8 Antenna extension scheme
- 2.9 Interface waterproofing
- 2.10 Pole and wall mounting
- 2.12 Antenna replacement
- Noteļ¼Replacement step reference to 2.4 Antenna ins
- Chapter 3 Broadcast Compliance Instructions
- Chapter 4 Precautions
- Chapter 5 Troubleshooting
- Notice to Users
- Contact Information
20
IoT Interworking
Make Your Life Smart
Security Code
Figure 6 Gateway body installation
As shown in the figure:
(1) Place the gateway on the bottom plate, align the screw holes on the side of the gateway (marked
with red box), and tighten the screws.
(2) Place the antenna holder above the lightning arrester, align the bottom plate screws (marked
with red box), and tighten the screws.
Note: