Specifications
Leader in IOT Embedded Solution
Page 15 of 15
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate the equipment. This device complies with part 15 of the FCC
Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation attenuation or filters depending
on the signal strength of any active beacons (if applicable) from the enabled radio(s). See ANSI
C63.4, ANSI C63.10 and ANSI C63.26 for further
The product under test is set into a link/association with a partnering WLAN device, as per the normal
intended use of the product. To ease testing, the product under test is set to transmit at a high duty
cycle, such as by sending a file or streaming some media content. ISED RSS Warning:
This device complies with Innovation, Science and Economic Development Canada licence-exempt
RSS standard(s). Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference, including
interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'ISED applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
(1) l'appareil ne doit pas produire de brouillage, et
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est
susceptible d'en compromettre le fonctionnement.
IC Label Instructions:
The outside of final products that contains this module device must display a label referring to the
enclosed module. This exterior label can use wording such as: “Contains Transmitter Module
IC: 25210-LSD043610D0”,or “Contains IC: 25210-LSD043610D0”, Any similar wording that
expresses the same meaning may be used.
L'extérieur des produits finis contenant ce module doit afficher une étiquette faisant référence au
module inclus. Cette étiquette extérieure peut utiliser des libellés tels que: contient le module
émetteur IC: 25210-LSD043610D0 ”ou“ contient: IC: 25210-LSD043610D0 ”, tout libellé similaire
exprimant lemême sens peut être utilisé.