Specifications

6 / 7
-Consult the dealer or an experienced radio/TV technician for help
- This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter.
RF Exposure Information and Statement :
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated with minimum distance of
20 cm between the radiator and your body. This transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter
ORIGINAL EQUIPMENT MANUFACTURER (OEM) NOTES
This module has been granted modular approval for mobile applications. OEM integrators for host products may use the module in their final
products without additional FCC/ISED (Innovation, Science and Economic Development Canada) certification if they meet the following
conditions. Otherwise, Additional FCC/IC approvals must be obtained.
The OEM must comply with the FCC labeling requirements. If the module’s label is not visible when installed, then an additional permanent label
must be applied on the outside of the finished product which states: ”Contains transmitter module FCC ID: 2AOFDLSD4BT-K5”. Additionally,
the following statement should be included on the label and in the final product’s user manual:
“This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interferences, and (2) this device must accept any interference received, including interference that may cause undesired operation.”
The user’s manual for the host product must clearly indicate the operating requirements and conditions that must be observed to ensure compliance
with current FCC / IC RF exposure guidelines.
The final host / module combination may also need to be evaluated against the FCC Part 15B criteria for unintentional radiators in order to be
properly authorized for operation as a Part 15 digital device.
This Module is full modular approval, it is limited to OEM installation ONLY.
The module is limited to installation in mobile application.
A separate approval is required for all other operating configurations, including portable configurations with respect to Part 2.1093 and difference
antenna configurations.
The OEM integrator is responsible for ensuring that the end-user has no manual instruction to remove or install module.
The Grantee will provide guidance to the Host Manufacturer for compliance with the Part 15B requirements if requested.