User's Manual

through the LBAP-102LU wireless device of the switching device. Then, the robot
can be automatically powered on.
3.2. Sorting
Robot sorting can be realized through the server. You can control the robots and
exchange data via wireless module with server software.
The server will try connecting all robots which have been powered on. After
normal connection, the server will keep being connected with the robots, acquire
information about robots’ current position via RFID codes and control robots’
walking or flapping according to state of current sorting platform.
3.3. Powering off
Robots are powered off with server software and switching devices. The robots
can be powered off by issuing corresponding commands to them through the LBAP-
102LU wireless device of the switching device with switching software of the server.
When the robot detects that the voltage of a single battery is lower than 2.1V, it
will shut down automatically.
A
ttachment 1. Practical Scenario
As shown in the figure below, the yellow one is the robot, which operates within
the platform.