User's Manual

4.2.Sorting
Robot sorting can be realized through the server. You can control the robots and
exchange data via wireless module with server software.
The server will try connecting all robots which have been powered on. After
normal connection, the server will keep being connected with the robots, acquire
information about robots’ current position via RFID codes and control robots’ walking
or flapping according to state of current sorting platform.
4.3.Powering off
Robots are powered off with server software and switching devices. The robots
can be powered off by issuing corresponding commands to them through the LBAP-
102LU wireless device of the switching device with switching software of the server.
The robot will automatically shut down when it detects that the battery voltage is
lower than 3.8v.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two
conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.