User's Manual

3.2. Sorting
Robot sorting can be realized through the server. You can control the robots and
exchange data via wireless module with server software.
The server will try connecting all robots which have been powered on. After
normal connection, the server will keep being connected with the robots, acquire
information about robots’ current position via RFID codes and control robots’
walking or
Liftingaccording to state of current sorting platform.
3.3. Pow
ering off
Robots are powered off with server software and switching devices. The robots
can be powered off by issuing corresponding commands to them through the LBAP-
102LU wireless device of the switching device with switching software of the server.
The robot will automatically shut down when it detects that the battery voltage is
lower than 3.8V.
FCC Statement
Any Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that
may cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class B
digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
—Consult the dealer or an experienced radio/TV technician for help.