Product Description

ManualsBrandsZhejiang Joytech Electronics ManualsElectronicsRemote controller

SPECIFICATION FOR APPROVAL

Customer: Zhejiang Joytech Electronics Co.,Ltd

Customer’s part number: 0100203006

Product description: 433.92MHz Rubber Duck Antenna

Uni Link’s part number: P00RD000433L

Issue Date: 2022/11/02

Note: 433.92MHz, RA SMA male

Customer Use

ustomer's

authorized signature

Remarks

Full approved

Conditional

approved

Rejected

Summary of content (7 pages)

PAGE 1
SPECIFICATION FOR APPROVAL Customer: Zhejiang Joytech Electronics Co.,Ltd Customer’s part number: 0100203006 Product description: 433.92MHz Rubber Duck Antenna Uni Link’s part number: P00RD000433L Issue Date: 2022/11/02 Note: 433.
PAGE 2
一、（Parameters）二、 (Specifications) 三、 ( Electrical Characteristic ) 四、（Mechanical Characteristic ）五、（Durability）
PAGE 3
一、Parameters POORD000433L MODEL Main Technical Specifications Frequency Range（MHz） 433 Bandwidth（MHz） 10 VSWR ≤2.5 Gain（dBi） 0 Max Input power（W） 5 Input Impedance（Ω） 50 Polarization Type Vertical Antenna Size（mm） 47*16.
PAGE 4
二、 Specifications
PAGE 5
三、 Electrical Characteristic ITEM 1 2 3 VSWR Smith Chart Gain Response TEST CONDITION Using PROTEK A333 networking analyzer to measure Antenna S1 VSWR characteristics Using PROTEK A333 networking analyzer to measure Antenna S1 Smith Chart characteristics Using PROTEK A333 networking analyzer to measure Antenna S1 Gain Response characteristics SPECIFICATION PIC 1 PIC 2
PAGE 6
四、 MECHANICAL CHARACTERISTICS 1 BENDING TEST 2 STRENG TEST Put load 120g at the end of the wire, fixed joints, swaying test at an angle of 60 degrees , test features after 1000 times No sign of damage 15 pounds of static load applied to the bottom of the actinomycetes end for one minute.
PAGE 7
五、 DURABILITY 1 2 3 4 SAIT SPRAY TEST HEAT TEST HUMIDITY TEST Standard：GB1266-86 Distilled Water： PH6.5~7.2 Spray Volume：1.0-2.0mL/80cm²/h Compressed Air Pressure：1Kgf/ cm² Test relativity：98° Temperature：34°~36° Pressure：46°~48° Time：24hr 75 +/- 3 ℃ for 1 hour, after keep in normal condition for 60mins,then test. All characteristic range is 30% of the initial value 40+2℃ 90-95%RH for 21hours, after keep in normal condition for 60mins, then test.