User's Manual Part 1

CHAPTER 2. START PRINTING 30
gear inside the print head, and then down past that into
the throat of the extruder. The Polar 3D support site has
aclipofthisprocess:
Polar 3D support document “Loading and Unloading Fila-
ment”
7. Check that the filament is p r operly i n se rt ed and engaged
with the filament drive gear as follows:
(a) From your device (phone, tablet, computer), connect
to the printer’s local IP address to access the printer’s
local web interface.(Ifyourlocalnetworkpermits
access from the Internet back to your printer’s local
IP address, you may instead conveniently access the
printer local web interface and perform such settings
while within the Polar Cloud. From the Polar Cloud
main menu, expand the left-hand menu and click on
“PRINTERS”, then click on the image of the printer you
are loading with filament; this will take you to the
printer’ s da shboard scr een ; see Figure 4.56.Atthat
screen, click on the “LOCAL UI”tab(gearicon)atthe
upper right, to navigate to the printer’s local web in-
terface.)
At t h e printer local web interface, see Fi gu r e 5.7,click
on the “Controls”tabfromtheverticalmenuonthe
right. At the “Manual Printer Controls”screen,en-
ter a temperature of 180°Candclickthe“SET”button;
see Figure 2.3.
(b) Once the extruder has warmed up, which you can see on
the Manual Printer Controls screen just underneath