User's Manual Part 1

CHAPTER 2. START PRINTING 28
2.1 Load filament
Figure 2. 1: L oa d filament onto the Polar3D printer
1. Swing out t h e spool holder arm from the back (see Fi gu r e
1.2)ofthePolar3Dprinter.
2. Unw ra p the spool of filament and place i t onto the spool
holder; see Figure 2.1.
3. Find the end of the string of filament.
4. Snip o↵ the end of the filament – perhaps an inch or two –
with a pair of scissors o r wire cl i p pers to get a good, clean