User's Manual Part 1

CHAPTER 1. GET CONNECTED TO THE POLAR CLOUD 25

static IP ad dr ess)anditsMAC address and contact your IT or

network administrator to ask them to open up access for your

printer.

1.3.4 Solving network connectivity problems

If your printer’s LED lights are not showing as POLAR3D

(blue over white), then the printer is not connected to the Polar

Cloud.

If the LED lights cycled:

1. POLAR3D ! POLAR3D ! POLAR3D (the LED lights

cycled from entirel y blue , to blue over red, before returning

to entirely blue): the printer searched for the speciﬁed local

network, but could not successfully connect.

(a) For WiFi connection, ﬁrst go back to the network pro-

ﬁle conﬁguration (step 7 in Section 1.1;seeinpartic-

ular Figure 1.6 ), and check that you entered the local

network password correctly!

(b) If using a static IP address, check that all those net-

working parameters were correctly entered; see Section

1.3.1.

ministrator that he or she has used your printer’s MAC

address to permit it access; see Section 1.3.2.

2. POLAR3D ! POLAR3D ! POLAR3D (the LED lights

cycled from entirely blue, to blue over red, befor e endin g

as blue over yellow): the printer successfully connected to