User's Manual Part 1

CHAPTER 1. GET CONNECTED TO THE POLAR CLOUD 11
the “ Polar3D” WiFi networ k from the Configured Network list
by clicking on the X mark right of it; see Figure 1.7.(Removing
the “Polar3D”networkwillpreventyourprinterfromattempt-
ing to connect to that network after power cycles; you want
your printer to attempt to connect first to your local network
when it powers on.) After removing Polar3D WiFi network,
your Configured Network screen should look similar to Figure
1.8.
You have n ow configured your 3D printer with a network
profile for yo ur l ocal network. But incorrect va l u es, such as for
the local network password (see Fig u r e 1.6), won’t be detected
until your printer attempts to actually connect...
Figure 1. 9: Restart the printer for local network connection attempt
Once your printer is configured to know how to connect to the
local network (and if necessary, the local network has been con-
figured by your network administrator to permit your printer
to connect), click the “Restart”tabontheleftnavigation
pane, and then click the “Confirm” button, see Figur e 1.9,to
have your printer attempt to connect to the local network, and