User's Manual Part 1

CHAPTER 1. GET CONNECTED TO THE POLAR CLOUD 4
via WiFi:
1. Unpack the build plate;itisamirroredglass
disk, that will arrive detached from the printer,
shipped in its own slot i n the foam p add i n g ma-
terial.
Apply a generou s quantity of Aqua Net Extra
Hold hair spray (included in the shippi n g box with
your Polar3D printer) to the build plate of your
new printer. You should apply a smooth and heavy
coat, so that the surface looks milky; for a video demonstration,
see:
https:/www. i n st a gr am . com / p / BJBa Wwr jCw F/
This will put a slightly sticky, bu t water soluble, layer on
the build plate, giving better adhesion when objects are print-
ing.
2. The printer arrives in its shipping box with the
print head completely lowered, and the build plate
(which is made of mirrored glass) not installed on
the printer build plate shuttle.Youwillneedtoraise
the print head in order to have room to place the
build plate on the printer build plate shuttle.
Twist the thr ead ed Zrodclockwise to raise the
print head.Raisingtheprintheadonetotwoinches
will give you room to install the build plate.
After you have unwrapped the build plate and
prepared its surface by applying a coat of hair spray (see above),
and raised the print head to make room for installing the build