User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989

6.2.3 Print from USB Flash Disk

①Insert your USB flash disk with target .g or .gx file to your InventorⅡ.

②Turn on the InventorⅡ. Make sure the build plate has been leveled and the filament

is loaded.

③Tap [Print] and then tap the SD Card icon in the middle. The file(s) will be

displayed on the screen. Select the file you want to print and tap [Print]. The file will

be transferred to the printer.

⑥And the printer will heat up the nozzle automatically and start to print after the

nozzle reaches the aimed temperature.,

Abort：To stop heating and printing. Once you tap [Abort], the process is irreversible.

Pause：To suspend the print job, you can tap it again to resume it. You can use this

function when you want to change the filament halfway.