User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989

5-19

If successfully connected, you will see the following red mark.

Connect ② InventorⅡ with your PC under STA mode

a. Turn on the WIFI of InventorⅡ and connect your PC with InventorⅡ via the

WIFI. Press [ Tools ], [ Setting ], [ WIFI ], and [ WIFI ON].

b.“InventorⅡ” continuous signal will be found available on the network list.

c. Once your PC is connected with your InventorⅡ. Open the Internet browser

and enter “10.10.100.254” and enter the default user name(admin) and

password(admin).

5-20

ƒ You will enter the WIFI setting panel, it displays as follows: