User Manual

InventorⅡ User Guide | www.flashforge.com 0086-0579-82273989

filament at a certain point.

(5-13) Click[Edit], then you can add or remove a height.

5.2.11 File Menus

①New Project

Click [File]--[New Project] can build a blank project. If there is an unsaved

modification on previous project, then it will inform you whether the modification

needs to be saved or not. Click [Yes] will save the modification, click [No] will

abandon it. If click [Cancel] or close tool tip, then will cancel the new project.

②Saving

After finishing the model edit and adjustment, there are two ways below to save all

models in the scene.

Method 1:

Click [File]--[Save Project] in the menu bar to save the file as a project file with the

“.fpp”suffix, all models in the scene (include support) are independent . After

reloading the files, extruder configuration information and model position will be the

same as the configuration during saving.

5-15

5-14