User's Manual

Inventor User Guide | www.flashf orge.com 0086‐ 0579‐82273989
72
a. X-Axis: Voltage parameter of X-axis stepper motor. The bigger the value i s, the
more heater will produce.
b. Y-Axis: Voltage parameter of Y-axis stepper motor. The bigger the value is, the
more heater will produce.
c. Z-Axis: Voltage parameter of Z-axis stepper motor. The bigger the value is, the
more heater will produce.
d. A-Axis: Voltage parameter of right-extruder stepper motor. The bigger the value is,
the more heater will produce.
e. B-Axis: Voltage parameter of left-extruder stepper motor. The bigger the value is,
the more heater will produce.
2
）
Others
a.Extrusion Ratio: The filament amount extruded by the extruder. Default: 109%
Max:125% (Usually the default ratio is suggested)
b. Path Width: The width of the path, the default value i s 0.4mm. Keeping default is
suggested.
c. Path Resolution: The default value is 0.1mm. The bigger the value is, the l ower the
extrusion r esolution is. On the contrary, the extrusion resolution is much higher.
8-7